The platform for mounting the GoPro, video Tx, etc is cut from 3mm plywood. I copied the profile from the foam canopy that came with the kit.
After a couple of slots have been added the two sections fit together.
Later I'll need to drill a small hole near the front for the screw which hold the platform down onto the nose.
I cut a hole for the tx cable and GoPro video leads to go through. The OSD and GPS modules will probably be fixed on the bottom of the platform.
Added some corners to keep the right angles tight and then the foam pads at the back which will squeeze into the fuselage roof.
No comments:
Post a Comment